2020-04-20
FM90 square shoulder milling cutter
Maintaing good?perpendicularity?at large cutting?depths?action
6?cutting edges?give high economical efficiency
Cutting edge wiper gives good surface quality
Suitable for?P?M?K?materials
Suitable for: face milling, square shoulder milling, slot milling
?
?
Responsible editor：http://www.
2020-04-20
Flying Stream series——New chip breaker for stainless steel cutting
Flying Stream?series——New chip breaker for stainless steel cutting
??
【PVD NEW GRADE ON ?STAINLESS STEEL】——OP1515
The?Carbide substrate?with uniform fine grains has very good edge strength and general performance，
The?New?PVD?coating technology??obtain a ?outstanding wear resistance, excellent thermal stability, chemical stability and adhesion resistance,
Suitable for all kinds of ISO M and low-carbon steel with continue and interrupt condition in low speed
【Semi-finishing ISO M material】——KMM
?
?Double?rake?angle design?，the cutting?edge?is more sharp and impact-resistance
?
?Variable?cutting edge?width design?guarantees good sureface and restrain groove wear
?
?Compare with OMM and MF ，suitable for all kinds of ?semi-finishing and finishing ISO M
?
?
?
Responsible editor：http://www.
2020-04-20
Sharp cutting edge design?，cutting quick and smooth
Smooth cutting edge treatment，high surface finish.
High quality substrate，good universality
?
?
Sharp cutting edge design?，cutting quick and smooth
?
Smooth cutting edge treatment，high surface finish.
?
High quality substrate，good universality
?
1、Reasonable chipbreaker design guarantee the chip-flowing well and high surface finish.
2、Sharp cutting edges structure combined with high toughness?、high wear-resistance and strong university carbide substrate makes the inserts cutting edge tough.
3、high wear-resistance coating makes the inserts with good applicability and universality.
?
?
Responsible editor：http://www.
2020-04-18
FM45 face milling cutter
??
8?cutting edges on?double?sides
Curved?cutting edge?design
Effectively?reduces cutting forces
Sharp edge?generates low?cutting?force
Cutting edge wiper gives good surface quality
?
?
Responsible editor：http://www.
2018-07-24
?
OK6110
A material with both abrasive resistance and toughness, It's the first recommended grade for turning tools . It's suitable for semi-finishing and finish of carbon steel, alloy steel .
OK6120
It has good toughness, thermal shock resistance and wear resistance. It's suitable for turning and milling of steel, especially for applications where requires high toughness.
?
?
?